AGP2E- Auto-Vac gasket set for Early P2 to 1 JS
Auto-Vac gasket set for early P2 to 1 JS. Set includes two top cover assembly gaskets, Fuel filter gasket, auto-vac control valve gasket, fuel tank control valve gasket, and drain plug gasket. Gaskets are made from composite cork/neoprene and are suitable for modern fuels with or without ethanol.
AGP2L- Auto-Vac gasket set for late P2 from 2 PY on
Auto-Vac gasket set for late P2 from 2 PY on. Set includes two top cover assembly gaskets, Fuel filter gasket, Auto-Vac control valve, and drain plug gasket. Gaskets are made from composite cork/neoprene and are suitable for modern fuels with or without ethanol.
AGP2M- Auto-Vac gasket set for mid-production P2 from 1 JS to 2 PY
Auto-Vac gasket set for mid-production P2 from 1 JS to 2 PY. Set includes two top cover assembly gaskets, Fuel filter gasket, two auto-vac control valve gaskets, and drain plug gasket. Gaskets are made from composite cork/neoprene and are suitable for modern fuels with or without ethanol.
E80282 Bracket for small exhaust system
Bracket for small exhaust system (connected to the carburetor induction heating exhaust system) intermediate pipe support reproduced in stainless steel. Includes two E80277 as pictured
Bracket for main silencer (Muffler) reproduced in stainless steel
AV2 Auto-Vac Valve Set
Auto-Vac valve set reproduced to exact original standards. Set includes air valve, fuel valve, and mounting hasp.
R7274 Ignition Rotor
Ignition rotor. Reproduced to the later design style to prevent spark from traveling down to the rotor post. Fits late British Silver Ghost using smaller Rolls-Royce type distributor as well as other Pre-War six cylinder models. Also fits AJS and AMS Series left hand drive Phantom II but requires that the end contact finger is flipped over.
AW Assort- Aluminum Washer Assortment
Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.
F74896- Shock Absorber Piston Link
Connects shock absorber internal piston to the shock absorber arm. For Rolls-Royce manufactured hydraulic shocks only. Applies to front and rear Phantom 1 and early Phantom 2 rear shocks only. It is an assembly of F74566 and F74896. This is New Old Stock.
PR6N- Electronic Ignition Conversion for Rolls-Royce P1, P2, 20, 20/25, 25/30, Bentley 3 1/2, 4 1/4
Electronic ignition conversion fits entirely inside the distributor with only two wires to connect. Includes new rotor, installation instructions, 30 month warranty, and technical assistance (if needed). We strongly recommend using the Pertronix 3.0 ohm coil for best reliability and performance. We provide 3.0 ohm coils with mounting studs to install on the original pedestal.
See more in the Extended Information section tab.
EDP1- Escutcheon Door Plates
Escutcheon Door Plates. This design is usually found on Brewster Coachbuilt cars. Can also be found on other types of American built bodies. They have been reproduced in stainless steel.
D50566a Distributor Cap
Distributor cap reproduced to very high standards. Includes carbon brush and screw in terminals. Can be used on left hand drive Phantom 2 as well, but the numbering on the cap will be reversed.
AC1 Window Regulator Gears for Common-Sense Window Lifts
The Common-Sense door window lifts were used in Brewster coachwork and perhaps other American cars. The gear set includes one large gear and one small gear. At times the original gears lose teeth and do not raise and lower properly.
E87157 Calorstat Radiator Shutter Control
Radiator shutter control unit. This is a rebuilt unit and carries a one year warranty. The bellows have been replaced, it has been re-soldered, pressure tested, and refilled with alcohol. The above price is for no core exchange. If a core can be supplied, the price is $475.Your old unit must be sent to us before a rebuilt unit is sent out.
G75378 Wheel Wrench
Wheel Wrench for wheel removal and installation. Reproduced to very high standards with excellent finishes.
TR2- TRILIN taillight (Right Side)
Trilin tail light without license plate light for right side. Reproduced in stainless steel with glass lenses. Configured with a double filament bulb socket to add in turn signals. Works with either six volt or twelve volt systems. Add visibility and safety while still maintaining an authentic appearance!