seal- leather for universal joint pin
Flared Ferrule Fitting for fuel and oil lines to be silver soldered onto 5/16" OD tubing and used with nut E75980 also availible.
Nut for Flared Ferrule Fitting E76000 for fuel and oil lines to be silver soldered onto 5/16" OD tubing. Thread is 9/16" BSF.
Seal- Bijur tank to firewall rubber fume seal. This part is actually a Post-War model part, however it is a good item to use on late Pre-War cars to help control fumes from entering the driver's compartment.
Starter drive retaining ring
Corrugated gasket for exhaust manifold to down pipe connection. Sold in pairs.
Steel disc external splined starter drive
Clutch disc starter drive
Spacer for side mount spare wheel 20/25 and 25/30
Rubber pad set for screw that attaches firewall to scuttle
Knob for instrument sliding light and ash tray. Threads onto a 1 1/6" x 16 TPI pull out. The OD is 1 1/2" and it is 9/16" high.
Brake shoe pull off spring
Ignition rotor. Reproduced to the later design style to prevent spark from traveling down to the rotor post. Fits late British Silver Ghost using smaller Rolls-Royce type distributor as well as other Pre-War six cylinder models. Also fits AJS and AMS Series left hand drive Phantom II but requires that the end contact finger is flipped over.
Spacer spherical for exhaust manifold to down pipe connection
Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.
Cover for starter relay switch for later 20/25 and later Phantom II on
Ignition Contacts for Late Phantom 1 and late 20hp on
Torque reaction damper friction disc, sold in pairs
Steering box rocking shaft, NOS
Starter Brush Set
Coil for Pre-War cars to mount on original pedistal with two studs. The appearance of this coil is subject to change.
Pedal pad set
Clip for Lucas bulb holder
Starter motor brush cover.
Rebuild kit for carburetor, Zenith single throat. Includes gaskets, accelerator pump, aluminum sealing washers, needle and seat, name badge, and idle screw
Clip only for holding the Lucas Inspection Lamp #97 and similar
Ignition Ballast Resistor complete
Water Pump Drive Spider, NOS.
Valve Spring Set of 12
Pin- for universal joint with needle bearings