EB221 Fan Belt
Fan Belt. Fits narrow pulleys used with four blade Phantom 3 as well.
AW Assort- Aluminum Washer Assortment
Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.
R7274 Ignition Rotor
Ignition rotor. Reproduced to the later design style to prevent spark from traveling down to the rotor post. Fits late British Silver Ghost using smaller Rolls-Royce type distributor as well as other Pre-War six cylinder models. Also fits AJS and AMS Series left hand drive Phantom II but requires that the end contact finger is flipped over.
E55315 Cylinder Head Gasket
Gasket joint for cylinder head to cylinder block. While our gaskets are not copper clad as the original, they work exceptionally well. They are to be installed following the original specifications and do not require more then 3 re-torquing sesions after installation provided the cylinder head studs are in good condition.
R7267 Water Pump Rebuild Kit
Water pump rebuild kit includes shaft- R7267, impeller- E57797, lead bushing- E5469, thrust button- E50203, and packing material. This kit does not apply to early 20/25 before chassis number GKT 10. If additional parts are required, please enquire. We will be happy to supply them. Additional costs will apply.
PR6N- Electronic Ignition Conversion for Rolls-Royce P1, P2, 20, 20/25, 25/30, Bentley 3 1/2, 4 1/4
Electronic ignition conversion fits entirely inside the distributor with only two wires to connect. Includes new rotor, installation instructions, 30 month warranty, and technical assistance (if needed). We strongly recommend using the Pertronix 3.0 ohm coil for best reliability and performance. We provide 3.0 ohm coils with mounting studs to install on the original pedestal.
See more in the Extended Information section tab.
G56756- Clutch Lining Set
Clutch linings are supplied undrilled. It is necessary to drill and counter bore these discs to attach them. If you wish, we would be happy to rivet them in place for you. Extra charges will be applied. This material works very well in this application. It is asbestos free but still retains very similar properties as the original material. It is recommended to also replace the cener plate, all springs, and all bearings at the time of renewing these linings.
D72503 Ignition Coil
Ignition coil reproduced for exact appearance of the original. Coil value is suitable for either points ignition or Pertronix Electronic Ignition Systems. Carries a 30 month warranty.
Please be aware- we have started reproducing these in small batches. If this item is not available immediately, it may take 2 weeks or more for stock to replenish.
E87157 Calorstat Radiator Shutter Control
Radiator shutter control unit. This is a rebuilt unit and carries a one year warranty. The bellows have been replaced, it has been re-soldered, pressure tested, and refilled with alcohol. The above price is for no core exchange. If a core can be supplied, the price is $475.Your old unit must be sent to us before a rebuilt unit is sent out.