Flared Ferrule Fitting for fuel and oil lines to be silver soldered onto 5/16" OD tubing and used with nut E75980 also availible.

Rotor ignition for DeJon distributor only

Nut for Flared Ferrule Fitting E76000 for fuel and oil lines to be silver soldered onto 5/16" OD tubing. Thread is 9/16" x 18tpi FOR SPRINGFIELD CARS ONLY

Carburetor float lever for operating needle valve. P2 up to chassis 100 MY

Spring plate for oil pressure relief valve

6 volt cars, such as late Springfield Silver Ghost and Springfield Phantom 1 require this lower resistance coil.

Distributor cap for DeJon distributor only.

Gasket set for inlet manifold to cylinder head- Aluminum Head engines only.
Set includes just the four gaskets shown

Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.

Replace the original filter screen with a modern paper type replaceable element using this adapter set-up.

Exhaust valve seat for aluminum cylinder head

Inlet valve seat for aluminum cylinder head

Cylinder head water jacket rear cover plate

Lock Tab Washer Set for Phantom 1 engine

Valve seat for inlet and exhaust for G2B series on, aluminum head

Wrench for Silver Ghost valve port caps, Springfield Phantom I engine oil drain plug and transmission oil filler plug. Reproduction

Water pump drive coupling

Ignition points set for American Bosch Distributors

Carburetor needle and seat valve. Includes aluminum sealing washer. Applies to early Phantom 2 to chassis 102 MY.

Spring for cam follower

Float chamber cover, reproduced.

AB6- Electronic Ignition Conversion for Springfield Silver Ghost + Springfield Phantom 1. This conversion is for the Bosch distributors only. At the time of placing an order for these, you must specify 6 volt or 12 volt, Negative or Positive ground. It is recommended to use the .6 ohm coil with this conversion.

Bushing set for connecting rod small end P1,P2. Requires fitting and honing to proper clearance.

Cylinder Head Gasket for Iron Head, reproduction

Cylinder Head Gasket for Aluminum Head, reproduction

Spark plug wire conduit for passenger's side of engine, for Springfield aluminum cylinder head only

Rollers and pins for UN-Splined cam followers. Before ordering verify which ones your engine has. Typically earlier series cars had un-splined followers, but some cars may have been changed to the splined type. When replacing rollers and pins it is recommended to use a special fixture to prevent pinching the fork onto the roller. Also it is best to replace the cam follower springs as well.

Rollers and pins for Splined cam followers. Before ordering verify which ones your engine has. Typically later series cars had splined followers, but some cars may have been changed to the un-splined type. When replacing rollers and pins it is recommended to use a special fixture to prevent pinching the fork onto the roller. Also it is best to replace the cam follower springs as well.

Camshaft reproduced to original specifications